CCNA RSE Lab
- 1.1.1.9 Lab – Mapping the Internet
- 1.1.4.6 Lab – Configuring Basic Router Settings with 105 CU
- 2.2.2.5 Lab – Configuring IPv4 Static and Default Routes
- 2.2.4.5 Lab – Configuring IPv6 Static and Default Routes
- 2.3.2.4 Lab – Troubleshooting IPv4 and IPv6 Static Routes
- 3.2.1.9 Lab – Configuring Basic RIPv2
- 5.1.1.6 Lab – Configuring Basic Switch Settings
- 5.2.2.9 Lab – Configuring Switch Security Features
- 6.2.2.5 Lab – Configuring VLANs and Trunking
- 6.2.3.9 Lab – Troubleshooting VLAN Configurations
- 6.3.2.4 Lab – Configuring Per-Interface Inter-VLAN Routing
- 6.3.3.7 Lab – Configuring 802.1Q Trunk-Based Inter-VLAN Routing
- 7.2.2.6 Lab – Configuring and Modifying Standard IPv4 ACL.s
- 7.2.3.4 Lab – Configuring and Verifying VTY Restrictions
- 8.1.2.4 Lab – Configuring Basic DHCPv4 on a Router
- 8.1.2.5 Lab – Configuring Basic DHCPv4 on a Switch
- 8.1.4.4 Lab – Troubleshooting DHCPv4
- 8.2.3.5 Lab – Configuring Stateless and Stateful DHCPv6
- 8.2.4.4 Lab – Troubleshooting DHCPv6
- 9.2.2.6 Lab – Configuring Dynamic and Static NAT
- 9.2.3.7 Lab – Configuring Port Address Translation (PAT)
- 9.3.1.5 Lab – TroubIeshooting NAT Confìurations
- 10.1.2.5 Lab – Configure CDP and LLDP
- 10.2.3.6 Lab – Configuring Syslog and NTP
- 10.3.1.9 Lab – Managing Router Configuration Files with Terminal Emulation Software
- 10.3.1.10 Lab – Managing Device Configuration Files Using TFTP, Flash, and USB
- 10.3.1.11 Lab – Configure and Verifý Password Recovery