CCNA 200-125 Exam: EIGRP Questions With Answers\
Question 1. A network administrator is troubleshooting an EIGRP problem on a router and needs to confirm the IP addresses of the devices with which the router has established adjacency. The retransmit interval and the queue counts for the adjacent routers also need to be checked. What command will display the required information?
A. Router# show ip eigrp neighbors
B. Router# show ip eigrp interfaces
C. Router# show ip eigrp adjacency
D. Router# show ip eigrp topology
Question 2. Which option describes a difference between EIGRP for IPv4 and IPv6?
A. Only EIGRP for IPv6 advertises all connected networks.
B. Only EIGRP for IPv6 requires a router ID to be configured under the routing process
C. AS numbers are configured in EIGRP but not in EIGRPv3.
D. Only EIGRP for IPv6 is enabled in the global configuration mode.
Question 3. Which EIGRP for IPv6 command can you enter to view the link-local addresses of the neighbors of a device?
A. show ipv6 eigrp 20 interfaces
B. show ipv6 route eigrp
C. show ipv6 eigrp neighbors
D. show ip eigrp traffic
Question 4. Which function allows EIGRP peers to receive notice of implementing topology changes?
B. advertised changes
C. goodbye messages
D. expiration of the hold timer
Question 5. What are the address that will show at the “show ip route” if we configure the above statements? (Choose three)
|router eigrp 100|
Question 6. What does split horizon prevent?
A. routing loops, link state
B. routing loops, distance vector
C. switching loops, STP
D. switching loops, VTP
Question 7. What is called when variance with two times of metric?
A. unequal cost load balancing
B. path selection
C. equal cost load balancing